Page 51 - LIT-18626-11-70

UF4D13E0.book Page 46 Wednesday, March 15, 2017 11:08 AM

Operation

(2) Turn the fuel cock knob to “ON”. (4) Pull the choke knob all the way out to
start a cold engine.

(3) Attach the engine shut-off cord (lanyard)
to your left wrist, and then attach the clip TIP:
to the engine shut-off switch. (See page The choke should not be used when the en-
23 for information on operating the en- gine is warm.
gine shut-off switch.) WARNING! Check (5) While lightly squeezing the throttle lever,
that the engine shut-off cord (lanyard) push the start switch (green button) to
is attached correctly. If the engine start the engine. (See page 23 for infor-
shut-off cord (lanyard) is not attached mation on operating the start switch.)
correctly, it may not pull free when the WARNING! Do not apply too much
operator falls off, allowing the water- throttle when starting the engine, oth-
craft to continue to run and cause an erwise the watercraft will accelerate
accident. [EWJ00582] unexpectedly. This could cause a col-
1 2 lision or cause the operator to be
thrown overboard. [EWJ00592]

START
3

1 Clip
2 Engine shut-off switch
3 Engine shut-off cord (lanyard)
(6) After the engine has warmed up, push
the choke knob in to its original position.
TIP:
If the choke knob is left pulled out, the engine
will stall.

46