Page 77 - LIT-18626-11-70

UF4D13E0.book Page 72 Wednesday, March 15, 2017 11:08 AM

Trouble recovery

(4) Open the fuse holder and replace the  The towline should be long enough so
fuse with one of the correct amperage. that the watercraft will not collide with
WARNING! Do not use fuses of a dif- the towing boat when slowing down.
ferent amperage than recommended.
If the watercraft becomes inoperative in the
Substitution with a fuse that has an
water, it can be towed to shore.
improper rating can cause extensive
To tow the watercraft:
electrical system damage and possi-
Use a towline that is three times the com-
ble fire. [EWJ00803]
bined length of the towing boat and the wa-
tercraft.
(1) Securely attach the towline to the bow
rope hole of the watercraft being towed.

1 Fuse holder
2 Electrical box
3 Fuse 1
4 Cap
1 Bow rope hole
Fuse amperage:
Battery fuse: (2) Ride the watercraft with your body
10 A weight supported on the riding tray. Hold
on to the handlebars in order to balance
(5) Insert the fuse holder into the electrical the watercraft and keep the bow up out
box. of the water. NOTICE: The bow must be
(6) Securely install the cap by tightening it kept up out of the water during tow-
until it stops. ing, otherwise water could flood the
(7) Securely install the hood in its original engine compartment or water could
position. flow back into the engine, causing se-
EJU34705 vere engine damage. [ECJ01331]
Towing the watercraft
Tow the watercraft at 8 km/h (5 mph) or less.
EWJ00812
NOTICE: Tow the watercraft at 8 km/h (5
WARNING
mph) or less, otherwise water could flood
 The operator of the towing boat must
the engine compartment or water could
keep speed to a minimum and avoid
flow back into the engine, causing severe
traffic or obstacles which could be a
engine damage. [ECJ01322]
hazard to the operator on the water-
craft.

72