Page 47 - LIT-18626-11-73

UF3J14E0.book Page 42 Friday, June 23, 2017 9:47 AM

Watercraft operation

To deactivate the no-wake mode: TIP:
Perform one of the following operations. The The beeps and the blinking digital speedom-
beeper sounds two times quickly and the di- eter display also indicate the activation of the
gital speedometer display stops blinking no-wake mode. (See page 41 for information
when the no-wake mode is deactivated. on the no-wake mode.)
 Push the “NO-WAKE MODE” switch. To activate the cruise assist:
 Squeeze the throttle lever. (1) Operate the throttle lever until the de-
 Squeeze the RiDE lever. sired engine speed is reached.
TIP: (2) When the engine speed reaches the de-
The no-wake mode is also deactivated when sired cruise assist setting, push the
the engine is stopped. “SET” switch. Once the beeper sounds
EJU37029 three times quickly and the digital speed-
Cruise assist
ometer display starts blinking, the cruise
The cruise assist is a function for maintaining
assist is activated. When the cruise as-
a desired engine speed within a fixed range
sist is activated, slowly squeeze the
while operating the watercraft.
throttle lever to keep it squeezed further
TIP: than the position at which the cruise as-
 The cruise assist can only be set between sist was set; releasing the throttle lever
engine speeds of approximately 3000 will deactivate the cruise assist.
r/min and approximately 7000 r/min.
TIP:
 The cruise assist cannot be activated in the
The digital speedometer display blinks con-
Low RPM Mode. (See page 40 for Low
tinually while the cruise assist is activated.
RPM Mode activation procedures.)
Make sure that the beeper has sounded and
Activating and deactivating the cruise as-
the digital speedometer display is blinking
sist
before squeezing the throttle lever to the full
Activation of the cruise assist will be con-
throttle position. If the speedometer display is
firmed by the number of beeps when the
not blinking, the cruise assist is not activated
“SET” switch, cruise assist up switch, or
cruise assist down switch is pushed, and by
the digital speedometer display of the multi-
function information center. (See page 44 for
information on the multifunction information
center.)
Digital
Number Cruise assist opera-
of beeps tion speedome-
ter display
Starts
Activated
blinking
Stops
Deactivated
blinking
Set engine speed in- Continues
creases or decreases blinking

42