Page 82 - LIT-18626-11-73

UF3J14E0.book Page 77 Friday, June 23, 2017 9:47 AM

Pre-operation checks

throttle lever returns automatically to its fully EJU32676
Switch checks
closed (idle) position when released. ECJ01311
NOTICE
Do not run the engine over 4000 r/min on
land. Also, do not run the engine for more
than 15 seconds without supplying water,
otherwise the engine could overheat.
Check the start switch, the engine stop
switch, and the engine shut-off switch for
proper operation. (See pages 32 to 32 for in-
formation on operating each switch.)
EJU40113
Remote control transmitter check 1 2 3
Make sure that the remote control transmitter
operates properly. (See page 31 for Yamaha
Security System setting procedures and
page 40 for Low RPM Mode activation pro-
cedures.)
EJU32664
Engine shut-off cord (lanyard) check
Make sure that the engine shut-off cord (lan- 4
yard) is not damaged. If the cord is damaged, 5
replace it. WARNING! Never try to repair 1 Clip
2 Engine shut-off switch
the engine shut-off cord (lanyard) or tie it
3 Start switch
together. The engine shut-off cord (lan-
4 Engine stop switch
yard) may not pull free when the operator
5 Engine shut-off cord (lanyard)
falls off, allowing the watercraft to conti-
To check the operation of the switches:
nue to run and cause an accident. [EWJ01221]
(1) If the lock mode is selected for the
Yamaha Security System setting, select
the unlock mode. (See page 31 for
Yamaha Security System setting proce-
dures.)
(2) Push the start switch to make sure that
the engine starts.
(3) As soon as the engine starts running,
push the engine stop switch to make
sure that the engine stops immediately.
(4) Restart the engine, and then pull the en-
gine shut-off cord (lanyard) to remove
the clip from the engine shut-off switch

77