Page 51 - LIT-18626-11-75

UF4G12E0.book Page 46 Tuesday, August 1, 2017 10:17 AM

Instrument operation

warning is activated, the maximum engine If the engine is stopped after the check en-
speed is limited. gine warning is activated, the information dis-
play will indicate an error code.

If the engine overheat warning is activated,
immediately reduce the engine speed, return If the check engine warning is activated, im-
to shore, and then make sure that water is mediately reduce the engine speed, return to
being discharged from the cooling water pilot shore, and have a Yamaha dealer check the
outlet while the engine is running. If there is engine.
no discharge of water, stop the engine, and EJU43740
Hour meter
then check the jet intake for clogging. (See
The hour meter shows the total number of
page 98 for information on the jet intake.)
hours that the engine has been running since
NOTICE: If you cannot locate and correct
the watercraft was new.
the cause of the overheating, consult a
Yamaha dealer. Continuing to operate at TIP:
higher speeds could result in severe en- The elapsed time will be kept even if the bat-
tery terminals have been disconnected.
gine damage. [ECJ00042]

1
1 Hour meter
EJU43731
Check engine warning EJU43751
If a sensor malfunction or a short circuit is de- Voltmeter
tected, the check engine warning indicator The voltmeter shows the battery voltage.
and the “WARNING” indicator light blink, and When the battery voltage is normal, the volt-
the buzzer sounds intermittently for 30 sec- meter displays approximately 12 volts.
onds.

46