Page 81 - LIT-18626-12-10

UF3V10E0.book Page 76 Thursday, August 23, 2018 9:17 AM

Pre-operation checks

throttle lever returns automatically to its fully than 15 seconds without supplying water,
closed (idle) position when released. otherwise the engine could overheat.
Check the start switch, the engine stop
switch, and the engine shut-off switch for
proper operation. (See pages 32 to 32 for in-
formation on operating each switch.)
1 2 3

EJU45350
Yamaha Security System check
Make sure that the Yamaha Security System
operates properly. (See page 31 for Yamaha 4
Security System setting procedures.) 5
EJU32664 1 Clip
Engine shut-off cord (lanyard) check 2 Engine shut-off switch
Make sure that the engine shut-off cord (lan- 3 Start switch
yard) is not damaged. If the cord is damaged, 4 Engine stop switch
replace it. WARNING! Never try to repair 5 Engine shut-off cord (lanyard)
the engine shut-off cord (lanyard) or tie it
To check the operation of the switches:
together. The engine shut-off cord (lan-
(1) If the lock mode is selected for the
yard) may not pull free when the operator
Yamaha Security System setting, select
falls off, allowing the watercraft to conti-
the unlock mode. (See page 31 for
nue to run and cause an accident. [EWJ01221]
Yamaha Security System setting proce-
dures.)
(2) Push the start switch to make sure that
the engine starts.
(3) As soon as the engine starts running,
push the engine stop switch to make
sure that the engine stops immediately.
(4) Restart the engine, and then pull the en-
gine shut-off cord (lanyard) to remove
the clip from the engine shut-off switch
to make sure that the engine stops im-
EJU32676
Switch checks mediately.
EJU45370
ECJ01311
NOTICE Electric trim system check
Turn on the multifunction information center,
Do not run the engine over 4000 r/min on and then operate the “TRIM/T.D.E.” switch-
land. Also, do not run the engine for more es. Check that the jet thrust nozzle moves up

76