Page 50 - LIT-18626-12-11

UF3X10E0.book Page 45 Tuesday, August 7, 2018 2:42 PM

Watercraft operation

Activating and deactivating the cruise as- squeezed further than the position at
sist which the cruise assist was set.
Activation of the cruise assist can be con-
TIP:
firmed by the cruise assist indicator on the
Check the multifunction information center to
multifunction information center.
make sure that the cruise assist is activated
before squeezing the throttle lever to the full
throttle position. If the cruise assist is not ac-
tivated, the engine will respond normally to
the throttle operation.
MPH
(4) Once the cruise assist is activated, push
Cruise Assist +4 the “SPEED CONTROL” up switch to in-
0 100%
crease the set engine speed or the
13.6V x100 F “SPEED CONTROL” down switch to de-
RPM
crease the set engine speed. The engine
1 2
speed can be changed in the range of
1 Cruise assist indicator
the cruise assist levels –5 to +5.
2 Cruise assist level
To activate the cruise assist: TIP:
(1) Operate the throttle lever until the de- Because the cruise assist can only be set be-
sired engine speed is reached. tween engine speeds of approximately 3000
(2) When the engine speed reaches the de- r/min and approximately 7000 r/min, the
sired cruise assist setting, push the cruise assist level cannot be adjusted to an
“SET” switch. Once the beeper sounds engine speed outside of this range.
three times and the cruise assist indica- To deactivate the cruise assist:
tor is displayed, the cruise assist is acti- Relax your grip on the throttle lever past the
vated. position at which the cruise assist was set.
The beeper sounds two times and the cruise
assist indicator disappears when the cruise
assist is deactivated.
1
2

3

1 “SPEED CONTROL” up switch
2 “SPEED CONTROL” down switch
3 “SET” switch
(3) When the cruise assist is activated, slow-
ly squeeze the throttle lever to keep it

45