Page 68 - LIT-18626-12-16

UF3Y12E0.book Page 63 Friday, April 27, 2018 1:38 PM

Pre-operation checks

whole range. Also, make sure that the RiDE falls off, allowing the watercraft to conti-
lever returns automatically to its fully closed nue to run and cause an accident. [EWJ01221]
position when released.

EJU40692
Switch checks
EJU42181
Throttle lever checks ECJ01311
Operate the throttle lever several times to NOTICE
make sure that operation is smooth through- Do not run the engine over 4000 r/min on
out the whole range. Also, make sure that the land. Also, do not run the engine for more
throttle lever returns automatically to its fully than 15 seconds without supplying water,
closed (idle) position when released. otherwise the engine could overheat.

Check the start switch, the engine stop
switch, and the engine shut-off switch for
proper operation. (See pages 31 to 31 for in-
formation on operating each switch.)
1

3

4
EJU32664
Engine shut-off cord (lanyard) check
Make sure that the engine shut-off cord (lan-
yard) is not damaged. If the cord is damaged, 2 5
replace it. WARNING! Never try to repair
the engine shut-off cord (lanyard) or tie it 1 Start switch
2 Engine stop switch
together. The engine shut-off cord (lan-
3 Engine shut-off switch
yard) may not pull free when the operator
4 Clip
5 Engine shut-off cord (lanyard)
To check the operation of the switches:
(1) Push the start switch to make sure that
the engine starts.

63