Page 48 - LIT-18626-12-57

UF3P13E0.book Page 42 Monday, June 24, 2019 1:32 PM

Instrument operation

EJU43760 their state before the center turned off, and
Multifunction information
then the center starts to operate normally.
center EJU35027
Information display
The multifunction information center displays
The information display shows watercraft op-
various watercraft information.
erating conditions.
1 2 3
1 2 3

4
1 “UNLOCK” indicator light 4 5 6 7 8 9
1 Trim indicator
2 Information display
2 Tachometer
3 “L-MODE” indicator light
3 Speedometer
4 “WARNING” indicator light
4 Oil pressure warning indicator
Multifunction information center initial op-
5 Engine overheat warning indicator
eration
6 Check engine warning indicator
When the multifunction information center is
7 Shift indicator
activated, all of the display segments come 8 Fuel level warning indicator
on. After 2 seconds, the warning indicators in 9 Fuel level meter
the information display go off, and then the
EJU43832
center starts to operate normally. Speedometer
If only the multifunction information center is The speedometer shows the watercraft
activated, the “WARNING” indicator light speed against water.
blinks once.
TIP:
The “UNLOCK” indicator light also comes on
as part of the initial operation.
The “UNLOCK” indicator light will go off
when the engine is started.
Multifunction information center standby
state
If the multifunction information center does
1
not receive any operation input within 25 sec-
1 Speedometer
onds after the engine stops, the center will
turn off and enter a standby state. When the By switching the display units, the speed can
engine is started again, the displays return to be shown in kilometers per hour “km/h” or
miles per hour “MPH”.

42