Page 49 - LIT-18626-12-57

UF3P13E0.book Page 43 Monday, June 24, 2019 1:32 PM

Instrument operation

TIP: The outer numbers × 1000 r/min and display
“MPH” is selected as the display unit at the segments on the meter show the engine
Yamaha factory. speed.
To switch the speedometer display units:
Start the engine, stop the engine, and then
push the engine stop switch 3 times, pushing
the switch for 0.4 seconds or more each time,
before the multifunction information center
turns off. The speedometer display units
change.
To switch the speedometer display units
again, repeat this procedure.
1
1 Tachometer
EJU43891
Shift indicator
This indicator shows the reverse gate shift
positions: “F” (forward), “N” (neutral), and “R”
(reverse). (See page 36 for shifting proce-
dures.)
1

1 Engine stop switch

2

3

4
1
1 Shift indicator
2 “F” (Forward position)
3 “N” (Neutral position)
1 4 “R” (Reverse position)
1 Speedometer EJU44010
Trim indicator
EJU31464
Tachometer This indicator shows the trim angle of the jet
The tachometer shows the engine speed. thrust nozzle. One of the two upper display
segments will be shown when the trim angle
is increased, and one of the two lower display
segments will be shown when the trim angle
is decreased. When the neutral position of
the jet thrust nozzle is selected, the middle

43