Page 67 - LIT-18626-12-60

UF4L11E0.book Page 61 Monday, June 24, 2019 2:27 PM

Pre-operation checks

falls off, allowing the watercraft to conti- (2) As soon as the engine starts running,
nue to run and cause an accident. [EWJ01221] push the engine stop switch to make
sure that the engine stops immediately.
(3) Restart the engine, and then pull the en-
gine shut-off cord (lanyard) to remove
the clip from the engine shut-off switch
to make sure that the engine stops im-
mediately.
EJU40102
Storage compartment checks
Make sure that the storage compartments
are not damaged and that water has not col-
lected in the compartments. (See page 44 for
EJU40692
Switch checks information on the storage compartments.)
ECJ01311 EJU44670
NOTICE Fire extinguisher holder checks
Make sure that the fire extinguisher holder is
Do not run the engine over 4000 r/min on
installed in the correct direction and is not
land. Also, do not run the engine for more
damaged. (See page 47 for information on
than 15 seconds without supplying water,
the fire extinguisher holder.)
otherwise the engine could overheat. EJU44620
Fire extinguisher check
Check the start switch, the engine stop Check that there is a full fire extinguisher on
switch, and the engine shut-off switch for board.
proper operation. (See pages 30 to 30 for in-
formation on operating each switch.)
1

3

4

2 5 To check the fire extinguisher, see the in-
structions supplied by the fire extinguisher
1 Start switch
manufacturer. Always keep the fire extin-
2 Engine stop switch
guisher stored in the holder.
3 Engine shut-off switch
4 Clip Always carry a fire extinguisher on board. A
5 Engine shut-off cord (lanyard) fire extinguisher is not standard equipment
with this watercraft. If you do not have one,
To check the operation of the switches:
contact a Yamaha dealer or a fire extinguish-
(1) Push the start switch to make sure that
the engine starts.

61