Page 97 - LIT-18626-12-61

UF3V11E0.book Page 91 Tuesday, June 18, 2019 5:16 PM

Care and storage

EJU37146 (4) Connect the garden hose adapter to a
Post-operation care
garden hose.
EWJ00331
WARNING
Always place the watercraft upright in a 1 2
horizontal position when storing it, other-
wise fuel could leak out into the engine or
engine compartment, which could create
a fire hazard.
After using the watercraft, always take it out
of the water, clean it, and store it. Leaving the
watercraft in the water for extended periods
1 Garden hose adapter
will accelerate the rate of normal deteriora-
2 Garden hose
tion of the jet pump and hull. Marine organ-
isms and corrosion are some of the (5) Loosen the flushing hose connector cap
conditions that can shorten the life of many and remove it. Insert the garden hose
watercraft components. adapter into the flushing hose connector
EJU42222 by pushing and twisting it until it is se-
Flushing the cooling water passages curely connected.
ECJ01311
NOTICE 1
Do not run the engine over 4000 r/min on 3
land. Also, do not run the engine for more
than 15 seconds without supplying water,
2
otherwise the engine could overheat.
Flush the cooling water passages to prevent
them from clogging with salt, sand, or dirt.
(1) Place the watercraft in a horizontal posi-
tion.
(2) Remove the seats and removable water-
tight storage compartment. (See page 54
for seat removal and installation proce- 1 Flushing hose connector
dures and page 59 for information on the 2 Flushing hose connector cap
3 Garden hose adapter
removable watertight storage compart-
ment.) (6) Connect the garden hose to a water tap.
(3) Open the stern storage compartment. (7) Make sure that the area around the wa-
(See page 58 for information on the stern tercraft is clear, and then start the en-
storage compartment.) gine. Immediately after the engine starts,
fully turn the water supply on so that wa-

91