Page 40 - LIT-18626-12-86

UF3V12E0.book Page 34 Wednesday, June 3, 2020 2:38 PM

Control function operation

(2) Make sure that the tilt lever returns to its TIP:
original position and that the handlebars  It will take about 60 seconds for the water
are securely locked in place. to reach the outlet after the engine is start-
ed.
 Water discharge may not be constant
when the engine is running at idling speed.
If this occurs, apply a little throttle to make
sure that water discharges properly.
EJU40323
Water separator
The water separator prevents water from en-
tering the fuel tank by collecting any water
that has entered the fuel tank breather hose if
the watercraft was capsized.
EJU35975
Cooling water pilot outlet If water has collected in the water separator,
When the engine is running, some of the drain it by loosening the drain screw.
cooling water that is circulated in the engine
is discharged from the cooling water pilot
outlet. 1
1 2

1 Water separator
2 Drain screw
To drain water from the water separator:
1 Cooling water pilot outlet
(1) Place a drain pan or dry cloth under the
There is a cooling water pilot outlet on the water separator.
port (left) side of the watercraft. To check for (2) Gradually loosen the drain screw to drain
proper operation of the cooling system, make the water. Catch the draining water in the
sure that water is being discharged from the drain pan or soak it up with the dry cloth
cooling water pilot outlet. If water is not being so that it does not spill into the engine
discharged from the outlet, stop the engine compartment. If any water spills into the
and check the jet intake for clogging. (See watercraft, be sure to wipe it up with a
page 105 for information on the jet intake.) dry cloth.
(3) Securely tighten the drain screw until it
stops.

34