Page 75 - LIT-18626-12-89

UF4R10E0.book Page 70 Tuesday, August 4, 2020 1:32 PM

Maintenance

(2) Remove the plastic fasteners, and then (7) Securely install the handlebar cover and
remove the handlebar cover. the plastic fasteners in their original posi-
tions.
(8) While holding the steering pole, move
the lock pin to the stowed position, and
then lower the steering pole.
EJU3128C
Adjusting the jet thrust nozzle angle
1 The angle of the jet thrust nozzle can be ad-
2
justed to two settings to suit operator prefer-
ence.
To adjust the jet thrust nozzle angle:
(1) Pull back the outer sleeve of the steering
1 Plastic fastener
2 Handlebar cover cable joint, and then disconnect the joint
from the steering cable pivot bolt.
(3) Turn the handlebars so that the left han-
dlebar grip is facing down.
(4) Loosen the locknut.
(5) Tighten or loosen the adjusting nut until
the desired amount of friction is ob-
tained.

1

1 Steering cable joint
(2) Remove the steering cable pivot bolt.
1

2
1 Adjusting nut
2 Locknut 2
(6) While holding the adjusting nut with a
wrench, tighten the locknut to the speci-
1
fied torque.
Tightening torque:
Locknut: 1 Steering cable pivot bolt
28 N·m (2.8 kgf·m, 21 lb·ft) 2 Steering column
(3) Select the nozzle angle, install the steer-
ing cable pivot bolt in the desired posi-
tion (P1 or P2) on the steering column,

70