Page 45 - LIT-18626-12-90

UF4P10E0.book Page 39 Friday, July 31, 2020 8:50 AM

Watercraft operation

EJU40002 speed can be adjusted to two levels: +1
Watercraft operation modes
and +2.
EJU45891
Reverse assist 1
The reverse assist is a function for temporar-
ily increasing the engine speed when moving
in reverse, such as to enter the water
smoothly when launching the watercraft from
TRIM
a trailer. T.D.E
This function operates after the engine is
started and only if the watercraft is not shifted
into forward.
1 RiDE lever
TIP:
Once the watercraft is shifted into forward af-
ter the engine is started, the reverse assist
cannot be operated.
Activating and deactivating the reverse
assist
The activation of the reverse assist can be
confirmed by the reverse assist indicator on
the multifunction information center.
1

1 “SPEED ADJUST” switch
RPM To deactivate the reverse assist:
x1000
Perform one of the following operations. The
MPH beeper sounds two times and the reverse as-
Reverse Assist +2 sist indicator disappears when the reverse
assist is deactivated.
14.3V
 Relax your grip on the RiDE lever.
1 2  Push the lower side of the “SPEED AD-
1 Reverse assist indicator JUST” switch when the reverse assist level
2 Reverse assist level is set to +1.
To activate the reverse assist:  Squeeze the throttle lever.
(1) Start the engine. EJU45900
T.D.E. (thrust directional enhancer)
(2) Squeeze the RiDE lever to the fully open
The T.D.E. is a function for slightly lifting or
position, and then push the upper side of
lowering the reverse gate from the neutral po-
the “SPEED ADJUST” switch. Once the
sition to operate the watercraft at very low
beeper sounds three times and the re-
speeds when the engine is running at idling
verse assist indicator is displayed, the
speed.
engine speed will increase. The engine
39