Page 50 - LIT-18626-12-90

UF4P10E0.book Page 44 Friday, July 31, 2020 8:50 AM

Watercraft operation

cruise assist indicator is displayed, the changed in the range of the cruise assist
cruise assist is activated. levels –5 to +5.

1 1
1 “CRUISE/NO WAKE” switch 1 “SPEED ADJUST” switch
(3) When the cruise assist is activated, slow- TIP:
ly squeeze the throttle lever to keep it Because the cruise assist can only be set be-
squeezed further than the position at tween engine speeds of approximately 3000
which the cruise assist was set. r/min and approximately 7000 r/min, the
TIP: cruise assist level cannot be adjusted to an
Check the multifunction information center to engine speed outside of this range.
make sure that the cruise assist is activated To deactivate the cruise assist:
before squeezing the throttle lever to the full Relax your grip on the throttle lever past the
throttle position. If the cruise assist is not ac- position at which the cruise assist was set.
tivated, the engine will respond normally to The beeper sounds two times and the cruise
the throttle operation. assist indicator disappears when the cruise
(4) Once the cruise assist is activated, push assist is deactivated.
the upper side of the “SPEED ADJUST”
switch to increase the set engine speed
or the lower side of the “SPEED AD-
JUST” switch to decrease the set engine
speed. The engine speed can be

44