Page 57 - LIT-18626-12-90

UF4P10E0.book Page 51 Friday, July 31, 2020 8:50 AM

Instrument operation

level meter, and the buzzer sounds intermit- If the check engine warning is activated, im-
tently. mediately reduce the engine speed, return to
shore, and have a Yamaha dealer check the
engine.
TIP:
Push the “OK” button of the touchpad control
RPM Low
x1000
Fuel
to display a description of the warning in the
center display.
MPH
Engine overheat warning “ ”
If the engine temperature rises
14.3V significantly, “ ” and “ ” are shown in the
warning bar, and the buzzer sounds continu-
If the fuel level warning is activated, refill the ously.
fuel tank as soon as possible. (See page 60
for information on filling the fuel tank.)
Battery voltage warning
If the battery voltage is less than 12 volts or
more than 18 volts when the engine is not If the engine overheat warning is activated,
running, the voltage display of the voltmeter immediately reduce the engine speed, return
blinks. to shore, and then make sure that water is
being discharged from the port (left) cooling
water pilot outlet while the engine is running.
If there is no discharge of water, stop the en-
gine, and then check the jet intake for clog-
RPM
x1000
ging. (See page 102 for information on the jet
intake.) NOTICE: If you cannot locate and
MPH
correct the cause of the overheating, con-
sult a Yamaha dealer. Continuing to oper-
ate at higher speeds could result in severe
10.8V
engine damage. [ECJ00042]
If the battery voltage warning is activated,
have the watercraft serviced by a Yamaha
dealer as soon as possible.
Check engine warning “ ”
If a sensor malfunction or a short circuit is
detected, “ ” is shown in the warning bar,
and the buzzer sounds intermittently.

51