Page 78 - LIT-18626-12-90

UF4P10E0.book Page 72 Friday, July 31, 2020 8:50 AM

Pre-operation checks

throttle lever returns automatically to its fully than 15 seconds without supplying water,
closed (idle) position when released. otherwise the engine could overheat.
Check the engine start/stop switch and the
engine shut-off switch for proper operation.
(See page 30 for information on operating
each switch.)
1
2

EJU45350
Yamaha Security System check
Make sure that the Yamaha Security System
operates properly. (See page 30 for Yamaha
Security System setting procedures.) 3
EJU32664 1 Clip
Engine shut-off cord (lanyard) check 2 Engine shut-off switch
Make sure that the engine shut-off cord (lan- 3 Engine shut-off cord (lanyard)
yard) is not damaged. If the cord is damaged,
replace it. WARNING! Never try to repair
the engine shut-off cord (lanyard) or tie it
together. The engine shut-off cord (lan-
yard) may not pull free when the operator
falls off, allowing the watercraft to contin-
ue to run and cause an accident. [EWJ01221]

1

1 Engine start/stop switch
To check the operation of the switches:
(1) If the lock mode is selected for the
Yamaha Security System setting, select
the unlock mode. (See page 30 for
Yamaha Security System setting proce-
dures.)
EJU46050
Switch checks (2) Push the engine start/stop switch to
ECJ01311 make sure that the engine starts.
(3) As soon as the engine starts running,
Do not run the engine over 4000 r/min on push the engine start/stop switch to
land. Also, do not run the engine for more

72