Page 102 - LIT-18626-12-93

UF4N10E0.book Page 95 Tuesday, September 29, 2020 8:02 AM

Operation

(4) Squeeze the RiDE lever and move the (2) Swim to the rear of the watercraft. Turn
watercraft back slowly. (See page 36 for the watercraft over by pulling on the ride
RiDE lever operation procedures.) plate with one hand while pushing down
EJU33114 on the gunwale with your other hand or
Boarding and starting off from a dock
(1) Board the watercraft from the side. your foot.
(2) Attach the engine shut-off cord (lanyard)
to your left wrist, and then attach the clip
to the engine shut-off switch.
(3) Push the watercraft away from the dock,
grip the handlebars with both hands, and
place both feet on the floor of the foot-
well.

(4) Look in all directions, start the engine,
and then start off slowly.
EJU44210
Capsized watercraft (3) Start the engine and operate the water-
EWJ00672
craft at planing speed to drain the bilge
water from the engine compartment.
Improper uprighting can cause injury. (See page 72 for information on draining
 Be sure to shut the engine off by pulling the bilge water. If the engine does not
on the engine shut-off cord (lanyard) to start, see “Towing the watercraft” on
remove the clip from the engine shut-off page 115 or “Submerged watercraft” on
switch. page 115.) NOTICE: Do not run the en-
 Do not put your hands in the intake gine at full throttle for at least 1 minute
grate. after the engine has been restarted.
Bilge water in the engine compart-
If the watercraft capsizes, turn it over imme-
ment can splash into the engine,
diately.
which can result in severe damage.
To upright the watercraft:
(1) Remove the clip from the engine shut-off [ECJ00554]
switch.

95