Page 40 - LIT-18626-12-93

UF4N10E0.book Page 33 Tuesday, September 29, 2020 8:02 AM

Control function operation

Insert the clip under the engine shut-off in 5 seconds, release the start switch, wait 15
switch before starting the engine. seconds, and then try again. NOTICE: Never
push the start switch while the engine is
running. Do not operate the start switch
1
for more than 5 seconds, otherwise the
battery will be discharged and the engine
will not start. Also, the starter motor could
be damaged. [ECJ01041]

2 1
3
1 Engine shut-off switch START
2 Clip
3 Engine shut-off cord (lanyard)
When the engine is not running, remove the
clip from the engine shut-off switch to pre-
vent accidental starting or unauthorized op-
eration by children or others. 1 Start switch
The engine will not start under any of the fol-
lowing conditions:
 Clip is removed from the engine shut-off
switch.
 Throttle lever is squeezed.
 Throttle lever is malfunctioning.
EJU31212
Throttle lever
The throttle lever increases the engine speed
when the lever is squeezed.
EJU46190
Start switch “ ” (VX-C) 1
ECJ01311

Do not run the engine over 4000 r/min on
land. Also, do not run the engine for more
than 15 seconds without supplying water,
otherwise the engine could overheat.

The start switch (green button) starts the en-
gine when the switch is pushed. 1 Throttle lever
Release the start switch as soon as the en-
The throttle lever returns automatically to its
gine starts to run. If the engine does not start
fully closed (idle) position when released.

33