Page 48 - LIT-18626-12-93

UF4N10E0.book Page 41 Tuesday, September 29, 2020 8:02 AM

Watercraft operation

TIP: Activating and deactivating the no-wake
mode
While the T.D.E. is activated, the “N” (neutral)
The activation of the no-wake mode can be
shift indicator will be displayed and “0” will be
confirmed by the no-wake mode indicator on
displayed on the speedometer.
the multifunction information center.
To deactivate the T.D.E.:
Perform one of the following operations. The
T.D.E. indicator disappears and the T.D.E. is
deactivated.
 Squeeze the throttle lever. MPH
 Squeeze the RiDE lever.
RPM
 Push and hold the “CRUISE/NO WAKE”
No Wake
switch.
 While moving forward at a very low speed, 14.3V
push the lower side of the “T.D.E.” switch. 1
 While moving in reverse at a very low
1 No-wake mode indicator
speed, push the upper side of the “T.D.E.”
To activate the no-wake mode:
switch.
(1) Shift into neutral, or release the throttle
TIP:
lever and let the engine speed return to
The T.D.E. is also deactivated when the en-
idle.
gine is stopped.
(2) Push and hold the “CRUISE/NO WAKE”
EJU46420
No-wake mode switch. Once the beeper sounds three
The no-wake mode is a function that main- times and the no-wake mode indicator is
tains the engine speed at a fixed setting for displayed, the no-wake mode is activat-
operating the watercraft at low speeds. ed.
This function can be used only when the wa-
tercraft is in neutral, or when the watercraft is
shifted into forward and the engine is operat-
ing at idling speed.
TIP:
If the no-wake mode is activated when the
watercraft is in neutral, the watercraft will au-
tomatically shift into forward and the water-
craft will start moving at a low speed. 1
1 “CRUISE/NO WAKE” switch
To deactivate the no-wake mode:
Perform one of the following operations. The
beeper sounds two times and the no-wake
mode indicator disappears when the no-
wake mode is deactivated.

41