Page 50 - LIT-18626-12-93

UF4N10E0.book Page 43 Tuesday, September 29, 2020 8:02 AM

Watercraft operation

To unlock the drive control mode: “CRUISE/NO WAKE” switch. Once the
(1) Select the drive control mode indicator. beeper sounds three times and the
(2) Input each digit of the 4-digit PIN, and cruise assist indicator is displayed, the
then push the “OK” button of the touch- cruise assist is activated.
pad control.
(3) Select “Lock”.
EJU46390
Cruise assist
The cruise assist is a function for maintaining
a desired engine speed within a fixed range
while operating the watercraft. Once the
cruise assist is activated, the set engine
speed can be increased or decreased. How-
ever, the adjustment is limited to a maximum 1
of five increments above or below the initial 1 “CRUISE/NO WAKE” switch
cruise assist setting.
(3) When the cruise assist is activated, slow-
TIP: ly squeeze the throttle lever to keep it
The cruise assist can only be set between en- squeezed further than the position at
gine speeds of approximately 4000 r/min and which the cruise assist was set.
approximately 7000 r/min.
TIP:
Activating and deactivating the cruise as-
sist Check the multifunction information center to
Activation of the cruise assist can be con- make sure that the cruise assist is activated
firmed by the cruise assist indicator on the before squeezing the throttle lever to the full
multifunction information center. throttle position. If the cruise assist is not ac-
tivated, the engine will respond normally to
the throttle operation.
(4) Once the cruise assist is activated, push
the upper side of the “SPEED ADJUST”
MPH
switch to increase the set engine speed
or the lower side of the “SPEED AD-
RPM
Cruise Assist +4 JUST” switch to decrease the set engine
speed. The engine speed can be
14.3V
1 2
1 Cruise assist indicator
2 Cruise assist level
To activate the cruise assist:
(1) Operate the throttle lever until the de-
sired engine speed is reached.
(2) When the engine speed reaches the de-
sired cruise assist setting, push the

43