Page 80 - LIT-18626-13-05

UF4P11E0.book Page 74 Friday, October 30, 2020 9:39 AM

Pre-operation checks

make sure that the engine stops immedi- EJU32535
Fire extinguisher check
ately.
Check that there is a full fire extinguisher on
(4) Restart the engine, and then pull the en-
board.
gine shut-off cord (lanyard) to remove
the clip from the engine shut-off switch
to make sure that the engine stops im-
mediately.
EJU46060
Electric trim system check
Turn on the multifunction information center,
and then operate the “TRIM/T.D.E.” switch.
Check that the jet thrust nozzle moves up and
down properly and that the trim setting indi-
cator change according to the operation of
the switch. (See page 45 for information on To check the fire extinguisher, see the in-
turning on the multifunction information cen- structions supplied by the fire extinguisher
ter without starting the engine and page 37 manufacturer. Always keep the fire extin-
for information on the electric trim system.) guisher secured in the holder with its cover in
place.
Always carry a fire extinguisher on board. A
fire extinguisher is not standard equipment
with this watercraft. If you do not have one,
contact a Yamaha dealer or a fire extinguish-
er dealer to obtain one meeting the proper
specifications.
Fire extinguisher:
Classification:
5-B (B-1)
EJU40102 Capacity:
Storage compartment checks
2 lb or more
Make sure that the storage compartments
are not damaged and that water has not col- EJU40122
lected in the compartments. (See page 57 for Safety equipment check
information on the storage compartments.) Check that safety equipment meeting the ap-
EJU43800 plicable regulations is on board.
Fire extinguisher holder, cover, and band EJU32353
checks Hull and deck check
Make sure that the fire extinguisher holder, Check the hull and deck for damage or other
cover, and band are not damaged and that problem.
the fire extinguisher is securely held in place EJU32657
Jet intake checks
using the band. (See page 59 for information Make sure that the jet intake is not damaged
on the fire extinguisher holder, cover, and or clogged with weeds or debris. If the jet in-
band.) take is clogged, clean it. (See page 103 for in-

74