Page 95 - LIT-18626-13-05

UF4P11E0.book Page 89 Friday, October 30, 2020 9:39 AM

Care and storage

EJU37146 (3) Connect the garden hose adapter to a
Post-operation care
garden hose.
EWJ00331

Always place the watercraft upright in a 1 2
horizontal position when storing it, other-
wise fuel could leak out into the engine or
engine compartment, which could create
a fire hazard.
After using the watercraft, always take it out
of the water, clean it, and store it. Leaving the
watercraft in the water for extended periods
1 Garden hose adapter
will accelerate the rate of normal deteriora-
2 Garden hose
tion of the jet pump and hull. Marine organ-
isms and corrosion are some of the (4) Loosen the flushing hose connector cap
conditions that can shorten the life of many and remove it. Insert the garden hose
watercraft components. adapter into the flushing hose connector
EJU46120 by pushing and twisting it until it is se-
Flushing the cooling water passages curely connected.
ECJ01880
2
 Do not run the engine over 4000 r/min on
land. Also, do not run the engine for
more than 15 seconds without supplying
water, otherwise the engine could over- 3 1
heat.
 Flush the cooling water passages to
prevent them from clogging with salt,
sand, or dirt.
1 Flushing hose connector cap
(1) Place the watercraft in a horizontal posi-
2 Garden hose adapter
tion.
3 Flushing hose connector
(2) Remove the seats and seat storage
(5) Connect the garden hose to a water tap.
compartment. (See page 54 for seat re-
(6) Make sure that the area around the wa-
moval and installation procedures and
tercraft is clear, and then start the en-
page 58 for information on the seat stor-
gine. Immediately after the engine starts,
age compartment.)
fully turn the water supply on so that wa-

89