Page 35 - LIT-18626-13-37

UF4R11E0.book Page 29 Friday, April 30, 2021 8:56 AM

Control function operation

EJU31273
Steering pole TIP:
The steering pole can be moved up or down  It will take about 60 seconds for the water
to change the height of the handlebars. to reach the outlet after the engine is start-
ed.
 Water discharge may not be constant
when the engine is running at idling speed.
If this occurs, apply a little throttle to make
sure that water discharges properly.
EJU40323
Water separator
The water separator prevents water from en-
tering the fuel tank by collecting any water
that has entered the fuel tank breather hose if
the watercraft was capsized.
EJU35975 If water has collected in the water separator,
Cooling water pilot outlet
When the engine is running, some of the drain it by loosening the drain screw.
cooling water that is circulated in the engine
is discharged from the cooling water pilot 1
outlet.
2

1

1 Water separator
2 Drain screw
To drain water from the water separator:
1 Cooling water pilot outlet (1) Place a drain pan or dry cloth under the
water separator.
There is a cooling water pilot outlet on the
(2) Gradually loosen the drain screw to drain
port (left) side of the watercraft. To check for
the water. Catch the draining water in the
proper operation of the cooling system, make
drain pan or soak it up with the dry cloth
sure that water is being discharged from the
so that it does not spill into the engine
cooling water pilot outlet. If water is not being
compartment. If any water spills into the
discharged from the outlet, stop the engine
watercraft, be sure to wipe it up with a
and check the jet intake for clogging. (See
dry cloth.
page 78 for information on the jet intake.)
(3) Securely tighten the drain screw until it
stops.

29