Page 100 - LIT-18626-13-44

UF3Y15E0.book Page 94 Tuesday, July 20, 2021 10:30 AM

Trouble recovery

ler, jet pump housing, and jet thrust noz-
zle. 1
If debris is difficult to remove, consult a
Yamaha dealer.
EJU43472
Raising the reverse gate (EX 2
DELUXE / EX LIMITED)
If the RiDE system malfunctions and the re-
verse gate remains in the lowered position,
the watercraft will not be able to move for-
ward. 1 Reverse gate
After raising the reverse gate so that the wa- 2 Forward position
tercraft can move forward, immediately re-
TIP
turn to shore and have a Yamaha dealer
service the watercraft.  While the shift rod is disconnected, the re-
verse gate will not move to the neutral po-
To raise the reverse gate:
sition or reverse position even if the RiDE
(1) Stop the engine and remove the clip from
lever is squeezed.
the engine shut-off switch.
 If the RiDE lever is squeezed while the shift
(2) Enter the water and move to the rear of
rod is disconnected, the watercraft will
the watercraft.
move forward.
(3) Slide the shift rod joint toward the bow,
and then disconnect the shift rod joint EJU34642
Jumping the battery
from the ball joint.
If the watercraft battery has run down, the en-
gine can be started using a 12-volt booster
battery and jumper cables.
EJU34666
Connecting the jumper cables
EWJ01252
1 2
To avoid battery explosion and serious
damage to the electrical system:
 Do not reverse the polarity of the jumper
cables when connecting to the batter-
1 Shift rod joint ies.
2 Ball joint  Do not connect the negative (–) jumper
(4) Raise the reverse gate to the forward po- cable to the negative (–) terminal of the
sition. watercraft battery.
 Do not touch the positive (+) jumper ca-
ble to the negative (–) jumper cable.

94