Page 40 - LIT-18626-13-94

UF4P13E0.book Page 33 Thursday, July 14, 2022 10:30 AM

Control function operation

bars may suddenly change position,
which may lead to an accident. [EWJ00042]

1

1
1 Cooling water pilot outlet
There are cooling water pilot outlets on the
1 Tilt lever
port (left) and starboard (right) sides of the
watercraft. To check for proper operation of
the cooling system, make sure that water is
being discharged from the port (left) pilot out-
let. If water is not being discharged from the
outlet, stop the engine and check the jet in-
take for clogging. (See page 104 for informa-
tion on the jet intake.)
TIP
 It will take about 60 seconds for the water
to reach the outlets after the engine is start-
(2) Make sure that the tilt lever returns to its ed.
original position and that the handlebars  Water discharge may not be constant
are securely locked in place. when the engine is running at idling speed.
If this occurs, apply a little throttle to make
sure that water discharges properly.

EJU40323
Water separator
The water separator prevents water from en-
tering the fuel tank by collecting any water
that has entered the fuel tank breather hose if
the watercraft was capsized.
If water has collected in the water separator,
drain it by loosening the drain screw.
EJU41801
Cooling water pilot outlets
When the engine is running, some of the
cooling water that is circulated in the engine
is discharged from the cooling water pilot
outlets.

33