Page 43 - LIT-18626-15-20

UF3X16E0.book Page 31 Wednesday, July 17, 2024 9:11 AM

Control function operation

than 15 seconds without supplying water, from the switch, such as if the operator falls
otherwise the engine could overheat. off the watercraft.
Insert the clip under the engine shut-off
The engine start/stop switch (red button)
switch before starting the engine.
starts the engine when the switch is pushed
while the engine is stopped, and stops the
engine when the switch is pushed while the 1
engine is running.
Release the engine start/stop switch as soon
as the engine starts to run. If the engine does
not start in 5 seconds, release the engine
start/stop switch, wait 15 seconds, and then 2
try again.
3
1 Engine shut-off switch
2 Clip
3 Engine shut-off cord (lanyard)
When the engine is not running, remove the
clip from the engine shut-off switch to pre-
vent accidental starting or unauthorized op-
eration by children or others.
1

1 Engine start/stop switch
The engine will not start under any of the fol-
lowing conditions:
 Lock mode of the Yamaha Security System
has been selected. (See page 30 for
Yamaha Security System setting proce-
dures.)
 Clip is removed from the engine shut-off
switch.
TIP
 Throttle lever is squeezed.
It is recommended that a spare engine shut-
 Throttle lever is malfunctioning.
off cord (lanyard) be stored in the glove com-
 RiDE lever is squeezed.
partment to allow a passenger to restart the
 RiDE lever is malfunctioning.
watercraft if the operator falls from the water-
EJU31165
Engine shut-off switch “ ” craft.
The engine shut-off switch automatically
EJU31212
stops the engine when the clip, on the end of Throttle lever
the engine shut-off cord (lanyard), is removed The throttle lever increases the engine speed
when the lever is squeezed.

31