Page 38 - LIT-18626-13-42

UF4S11E0.book Page 31 Thursday, July 29, 2021 9:31 AM

Control function operation

EJU46112 EJU31164
Engine start/stop switch “ / ” Engine shut-off switch “ ”
ECJ01311 The engine shut-off switch automatically
stops the engine when the clip, on the end of
Do not run the engine over 4000 r/min on the engine shut-off cord (lanyard), is removed
land. Also, do not run the engine for more from the switch, such as if the operator falls
than 15 seconds without supplying water, off the watercraft.
otherwise the engine could overheat. Insert the clip under the engine shut-off
switch before starting the engine.
The engine start/stop switch (red button)
starts the engine when the switch is pushed
while the engine is stopped, and stops the 1
engine when the switch is pushed while the
engine is running.
Release the engine start/stop switch as soon
as the engine starts to run. If the engine does
not start in 5 seconds, release the engine 2
start/stop switch, wait 15 seconds, and then
try again. 3
1 Engine shut-off switch
2 Clip
3 Engine shut-off cord (lanyard)
When the engine is not running, remove the
clip from the engine shut-off switch to pre-
vent accidental starting or unauthorized op-
eration by children or others.
1

1 Engine start/stop switch
The engine will not start under any of the fol-
lowing conditions:
 Lock mode of the Yamaha Security System
has been selected. (See page 30 for
Yamaha Security System setting proce-
dures.)
 Clip is removed from the engine shut-off
EJU31212
switch. Throttle lever
 Throttle lever is squeezed. The throttle lever increases the engine speed
 Throttle lever is malfunctioning. when the lever is squeezed.
 RiDE lever is squeezed.
 RiDE lever is malfunctioning.

31