Page 40 - LIT-18626-13-42

UF4S11E0.book Page 33 Thursday, July 29, 2021 9:31 AM

Control function operation

1
2

1
1 Cooling water pilot outlet 1 Water separator
There is a cooling water pilot outlet on the 2 Drain screw
port (left) side of the watercraft. To check for To drain water from the water separator:
proper operation of the cooling system, make (1) Place a drain pan or dry cloth under the
sure that water is being discharged from the water separator.
cooling water pilot outlet. If water is not being (2) Gradually loosen the drain screw to drain
discharged from the outlet, stop the engine the water. Catch the draining water in the
and check the jet intake for clogging. (See drain pan or soak it up with the dry cloth
page 103 for information on the jet intake.) so that it does not spill into the engine
TIP compartment. If any water spills into the
 It will take about 60 seconds for the water watercraft, be sure to wipe it up with a
to reach the outlet after the engine is start- dry cloth.
ed. (3) Securely tighten the drain screw until it
 Water discharge may not be constant stops.
when the engine is running at idling speed.
If this occurs, apply a little throttle to make
sure that water discharges properly.
EJU40323
Water separator
The water separator prevents water from en-
tering the fuel tank by collecting any water
that has entered the fuel tank breather hose if
the watercraft was capsized.
If water has collected in the water separator,
drain it by loosening the drain screw.

33