Page 48 - LIT-18626-13-96

UF4S12E0.book Page 41 Friday, July 15, 2022 9:17 AM

Watercraft operation

EJU45930
Cruise assist
The cruise assist is a function for maintaining
a desired engine speed within a fixed range
while operating the watercraft. Once the
cruise assist is activated, the set engine
speed can be increased or decreased. How-
ever, the adjustment is limited to a maximum
of five increments above or below the initial
cruise assist setting. 1
TIP 1 “CRUISE/NO WAKE” switch
The cruise assist can only be set between en- (3) When the cruise assist is activated, slow-
gine speeds of approximately 3000 r/min and ly squeeze the throttle lever to keep it
approximately 7000 r/min. squeezed further than the position at
which the cruise assist was set.
Activating and deactivating the cruise as-
sist TIP
Activation of the cruise assist can be con- Check the multifunction information center to
firmed by the cruise assist indicator on the make sure that the cruise assist is activated
multifunction information center. before squeezing the throttle lever to the full
throttle position. If the cruise assist is not ac-
tivated, the engine will respond normally to
the throttle operation.

MPH
(4) Once the cruise assist is activated, push
the upper side of the “SPEED ADJUST”
RPM
Cruise Assist +4 switch to increase the set engine speed
or the lower side of the “SPEED AD-
14.3V JUST” switch to decrease the set engine
1 2 speed. The engine speed can be
1 Cruise assist indicator changed in the range of the cruise assist
2 Cruise assist level levels –5 to +5.
To activate the cruise assist:
(1) Operate the throttle lever until the de-
sired engine speed is reached.
(2) When the engine speed reaches the de-
sired cruise assist setting, push the
“CRUISE/NO WAKE” switch. Once the
beeper sounds three times and the
cruise assist indicator is displayed, the
cruise assist is activated.

41