Page 65 - LIT-18626-13-99

UF6C11E0.book Page 59 Tuesday, July 19, 2022 4:21 PM

Pre-operation checks

1
2

3
1 Clip
EJU32666
Engine shut-off cord (lanyard) check 2 Engine shut-off switch
Make sure that the engine shut-off cord (lan- 3 Engine shut-off cord (lanyard)
yard) is not damaged. If the cord is damaged,
replace it. WARNING! Never try to repair
the engine shut-off cord (lanyard) or tie it
together. The engine shut-off cord (lan-
yard) may not pull free when the operator
falls off, allowing the watercraft to conti-
nue to run and cause an accident. [EWJ01222]
1

1 Engine start/stop switch
To check the operation of the switches:
(1) Push the engine start/stop switch to
make sure that the engine starts.
(2) As soon as the engine starts running,
push the engine start/stop switch to
make sure that the engine stops immedi-
EJU47141
Switch checks ately.
ECJ01311
(3) Restart the engine, and then pull the en-
gine shut-off cord (lanyard) to remove
Do not run the engine over 4000 r/min on the clip from the engine shut-off switch
land. Also, do not run the engine for more to make sure that the engine stops im-
than 15 seconds without supplying water, mediately.
otherwise the engine could overheat. EJU47210
Electric trim system check
Check the engine start/stop switch and the Turn on the multifunction information center,
engine shut-off switch for proper operation. and then operate the “TRIM” switch. Check
(See page 30 for information on operating that the jet thrust nozzle moves up and down
each switch.) properly and that the trim indicator change

59