Page 53 - LIT-18626-14-57

UF3X15E0.book Page 44 Friday, June 23, 2023 4:14 PM

Watercraft operation

Activating and deactivating the cruise as- TIP
sist Check the multifunction information center to
Activation of the cruise assist can be con-
make sure that the cruise assist is activated
firmed by the cruise assist indicator on the
before squeezing the throttle lever to the full
multifunction information center.
throttle position. If the cruise assist is not ac-
tivated, the engine will respond normally to
F
the throttle operation.
(4) Once the cruise assist is activated, push
the upper side of the “SPEED ADJUST”
MPH
switch to increase the set engine speed
RPM
CRUISE ASSIST +1 E
or the lower side of the “SPEED AD-
OFF PM JUST” switch to decrease the set engine
12.7 v
speed. The engine speed can be
1 2 changed in the range of the cruise assist
1 Cruise assist indicator levels –5 to +5.
2 Cruise assist level
To activate the cruise assist:
(1) Operate the throttle lever until the de-
sired engine speed is reached.
(2) When the engine speed reaches the de-
sired cruise assist setting, push the
“CRUISE/NO WAKE” switch. Once the
beeper sounds three times and the
cruise assist indicator is displayed, the 1
cruise assist is activated.
1 “SPEED ADJUST” switch
TIP
Because the cruise assist can only be set be-
tween engine speeds of approximately 3000
r/min and approximately 7000 r/min, the
cruise assist level cannot be adjusted to an
engine speed outside of this range.
To deactivate the cruise assist:
1
Relax your grip on the throttle lever past the
1 “CRUISE/NO WAKE” switch position at which the cruise assist was set.
(3) When the cruise assist is activated, slow- The beeper sounds two times and the cruise
ly squeeze the throttle lever to keep it assist indicator disappears when the cruise
squeezed further than the position at assist is deactivated.
which the cruise assist was set.

44