Page 105 - LIT-18626-14-58

UF7K10E0.book Page 96 Thursday, July 13, 2023 5:40 PM

Pre-operation checks

than 15 seconds without supplying water, make sure that the engine stops immedi-
otherwise the engine could overheat. ately.
(4) Restart the engine, and then pull the en-
Check the engine start/stop switch and the
gine shut-off cord (lanyard) to remove
engine shut-off switch for proper operation.
the clip from the engine shut-off switch
(See page 30 for information on operating
to make sure that the engine stops im-
each switch.)
mediately.
1 EJU47011
2 Electric trim system check
Turn on the multifunction information center,
and then operate the “TRIM/T.D.E.” switch.
Check that the jet thrust nozzle moves up and
down properly and that the trim setting indi-
cator change according to the operation of
the switch. (See page 46 for information on
turning on the multifunction information cen-
3 ter without starting the engine and page 37
1 Clip for information on the electric trim system.)
2 Engine shut-off switch
3 Engine shut-off cord (lanyard)

1 EJU40102
Storage compartment checks
1 Engine start/stop switch Make sure that the storage compartments
are not damaged and that water has not col-
To check the operation of the switches:
lected in the compartments. (See page 78 for
(1) If the lock mode is selected for the
information on the storage compartments.)
Yamaha Security System setting, select
EJU41082
the unlock mode. (See page 30 for Fire extinguisher holder, cover, and band
Yamaha Security System setting proce- checks
Make sure that the fire extinguisher holder,
dures.)
cover, and band are not damaged and that
(2) Push the engine start/stop switch to
the cover is securely held in place using the
make sure that the engine starts.
band. (See page 81 for information on the fire
(3) As soon as the engine starts running,
extinguisher holder, cover, and band.)
push the engine start/stop switch to
96