Page 48 - LIT-18626-14-58

UF7K10E0.book Page 39 Thursday, July 13, 2023 5:40 PM

Watercraft operation

EJU40003 speed can be adjusted to two levels: +1
Watercraft operation modes
and +2.
EJU47340
Reverse assist 1
The reverse assist is a function for temporar-
ily increasing the engine speed when moving
in reverse, such as to enter the water
smoothly when launching the watercraft from
a trailer.
This function operates after the engine is
started and only if the watercraft is not shifted
into forward.
1 RiDE lever
TIP
Once the watercraft is shifted into forward af-
ter the engine is started, the reverse assist
cannot be operated.

Activating and deactivating the reverse
assist
The activation of the reverse assist can be
confirmed by the reverse assist indicator on
the multifunction information center.
1
F 1 “SPEED ADJUST” switch
To deactivate the reverse assist:
Perform one of the following operations. The
beeper sounds two times and the reverse as-
MPH
RPM sist indicator disappears when the reverse
REVERSE ASSIST +1 E
assist is deactivated.
OFF PM
12.7 v  Relax your grip on the RiDE lever.
 Push the lower side of the “SPEED AD-
1 2
1 Reverse assist indicator JUST” switch when the reverse assist level
2 Reverse assist level is set to +1.
 Squeeze the throttle lever.
To activate the reverse assist:
EJU45900
(1) Start the engine. T.D.E. (thrust directional enhancer)
(2) Squeeze the RiDE lever to the fully open The T.D.E. is a function for slightly lifting or
position, and then push the upper side of lowering the reverse gate from the neutral po-
the “SPEED ADJUST” switch. The re- sition to operate the watercraft at very low
verse assist indicator is displayed, the speeds when the engine is running at idling
engine speed will increase. The engine speed.

39