Page 105 - LIT-18626-14-62

UF4N13E0.book Page 97 Tuesday, June 6, 2023 9:38 AM

Care and storage

EJU37148
Post-operation care
EWJ00332 1 2

Always place the watercraft upright in a
horizontal position when storing it, other-
wise fuel could leak out into the engine or
engine compartment, which could create
a fire hazard.
After using the watercraft, always take it out
1 Garden hose adapter
of the water, clean it, and store it. Leaving the
2 Garden hose
watercraft in the water for extended periods
will accelerate the rate of normal deteriora- (4) Loosen the flushing hose connector cap
tion of the jet pump and hull. Marine organ- and remove it. Insert the garden hose
isms and corrosion are some of the adapter into the flushing hose connector
conditions that can shorten the life of many by pushing and twisting it until it is se-
watercraft components. curely connected.
EJU46370
Flushing the cooling water passages 2 3
ECJ01311
Do not run the engine over 4000 r/min on
land. Also, do not run the engine for more 1
than 15 seconds without supplying water,
otherwise the engine could overheat.
Flush the cooling water passages to prevent
them from clogging with salt, sand, or dirt.
(1) Place the watercraft in a horizontal posi-
tion.
(2) Remove the seats. (See page 60 for seat
removal and installation procedures.)
1 Flushing hose connector cap
(3) Connect the garden hose adapter to a
2 Flushing hose connector
garden hose.
3 Garden hose adapter
(5) Connect the garden hose to a water tap.
(6) Make sure that the area around the wa-
tercraft is clear, and then start the en-
gine. Immediately after the engine starts,
fully turn the water supply on so that wa-
ter flows out continually from the jet
thrust nozzle.

97