Page 106 - LIT-18626-14-62
P. 106

UF4N13E0.book  Page 98  Tuesday, June 6, 2023  9:38 AM



                        Care and storage

                                                                 proofing the  internal engine  compo-
                                                                 nents.)
                                                              (3) Rinse  the engine and engine compart-
                                                                 ment with a small amount of  water.
                                                                 NOTICE: Do not use high-pressure
                                                                 water when rinsing the engine or en-
                                                                 gine  compartment as severe engine
                                                                 damage could result. [ECJ00572]
                                                              (4) Drain  the water  from the engine com-
                                                                 partment. (See page 71 for information
                        (7) Run the engine at idling speed for about  on draining the bilge water.)
                            3 minutes watching the engine condition.  (5) Wipe  the engine  and engine compart-
                            If the  engine stops  while flushing,  turn  ment with a dry cloth.
                            the water supply off immediately  and  (6) Wash down the hull, deck, and jet pump
                            perform the procedure again from step 6.  with fresh water.
                            NOTICE: Do not supply water to the
                                                              (7) Wipe the hull, deck, and jet pump with a
                            cooling water passages when the en-
                                                                 dry cloth.
                            gine is not running. The water could
                                                              (8) Wipe  all vinyl and rubber components,
                            flow back through the muffler into the
                                                                 such as the seats and engine compart-
                            engine, causing severe engine  dam-
                                                                 ment seals, with a vinyl protectant such
                            age. [ECJ00123]
                                                                 as Yamaclean Vinyl Dressing™.
                        (8) Turn the water supply off.
                                                              (9) To minimize corrosion, spray metallic
                        (9) Discharge the remaining water out of the
                                                                 parts of the hull, deck, and engine with a
                            cooling  water passages by  alternately
                                                                 rust inhibitor such as Yamalube Silicone
                            squeezing and releasing the throttle lever
                                                                 Protectant & Lubricant.
                            quickly for 10 to 15 seconds.
                                                              (10) Allow the engine compartment to air dry
                        (10) Stop the engine.                    completely before installing the seats.
                        (11) Remove the garden hose adapter, and
                                                              (11) Securely install the seats in their original
                            then securely install the flushing hose
                                                                 positions.
                            connector cap  by tightening  it until it  EJU41636
                            stops.                            Battery care
                        (12) Securely install seats in their original po-  If the watercraft will not be used for more than
                            sitions.                          a month, remove the battery from the water-
                                                              craft, check it, and then store it in a cool, dry
                        EJU43931
                        Cleaning the watercraft               place.
                        (1) Remove the seats. (See page 60 for seat  EWJ00794
                            removal and installation procedures.)
                        (2) If the watercraft will be stored for a week  Battery electrolyte is poisonous and dan-
                            or more,  rustproof  the internal engine  gerous, causing severe burns, etc. Elec-
                            components to help prevent corrosion.  trolyte contains sulfuric acid. Avoid
                            (See page 101 for information on rust-  contact with skin, eyes, or clothing.

                        98
   101   102   103   104   105   106   107   108   109   110   111