Page 54 - LIT-18626-15-22

UF4P15E0.book Page 44 Wednesday, June 26, 2024 11:56 AM

Watercraft operation

while operating the watercraft. Once the
cruise assist is activated, the set engine
speed can be increased or decreased. How-
ever, the adjustment is limited to a maximum
of five increments above or below the initial
cruise assist setting.
TIP
The cruise assist can only be set between en-
gine speeds of approximately 3000 r/min and 1
approximately 7000 r/min.
1 “CRUISE/NO WAKE” switch
Activating and deactivating the cruise as- (3) When the cruise assist is activated, slow-
sist
ly squeeze the throttle lever to keep it
Activation of the cruise assist can be con-
squeezed further than the position at
firmed by the cruise assist indicator on the
which the cruise assist was set.
multifunction information center.
TIP
Check the multifunction information center to
make sure that the cruise assist is activated
before squeezing the throttle lever to the full
throttle position. If the cruise assist is not ac-
tivated, the engine will respond normally to
the throttle operation.
Cruise Assist +2
(4) Once the cruise assist is activated, push
the upper side of the “SPEED ADJUST”
1 2 switch to increase the set engine speed
1 Cruise assist indicator
or the lower side of the “SPEED AD-
2 Cruise assist level
JUST” switch to decrease the set engine
To activate the cruise assist: speed. The engine speed can be
(1) Operate the throttle lever until the de- changed in the range of the cruise assist
sired engine speed is reached. levels –5 to +5.
(2) When the engine speed reaches the de-
sired cruise assist setting, push the
“CRUISE/NO WAKE” switch. Once the
beeper sounds three times and the
cruise assist indicator is displayed, the
cruise assist is activated.

44