Page 100 - LIT-18626-15-24
P. 100

UF7M11E0.book  Page 90  Friday, June 7, 2024  11:25 AM



                        Operation

                                                              (2) Release the throttle lever  to  reduce
                                                                 speed about 115 m (380 ft) before you
                                                                 reach the intended beaching area.
                                                              (3) Slowly approach the beach  using  the
                                                                 throttle lever and RiDE  lever  to  control
                                                                 the watercraft speed.  NOTICE: Never
                                                                 run the  engine in water that is  less
                                                                 than 60 cm (2 ft) deep from the bottom
                                                                 of the watercraft, otherwise pebbles
                                                                 or sand could be sucked into the jet
                                                                 intake, causing impeller damage and
                                                                 engine overheating. [ECJ00473]
                                                              (4) After reaching land, stop the engine, and
                                                                 then get off the watercraft and pull it up
                                                                 on the beach.
                                                              To dock the watercraft:
                                                              (1) Make sure that there are no boats, swim-
                                                                 mers, or obstacles near the dock.
                                                              (2) Release the throttle lever  to  reduce
                                                                 speed about 115 m (380 ft) away from
                        (3) Start the engine and operate the water-
                                                                 the dock.
                            craft at planing speed to drain the bilge
                                                              (3) Slowly approach the dock  using the
                            water from the  engine  compartment.
                                                                 throttle lever and RiDE  lever  to  control
                            (See page 68 for information on draining
                                                                 the watercraft speed.
                            the bilge water. If the engine does  not
                                                              (4) After coming alongside the dock, stop
                            start, see “Towing  the  watercraft” on
                                                                 the engine, and then get off the water-
                            page 109 or “Submerged watercraft” on
                                                                 craft.
                            page 109.) NOTICE: Do not run the en-
                                                              EJU37194
                            gine at full throttle for at least 1 minute  Operating in weeded areas
                            after the engine has been restarted.  Always avoid using your watercraft in areas
                            Bilge water  in  the engine compart-  where weed growth is thick. If operating in
                            ment can splash into the  engine,  weeded areas is unavoidable, alternately
                            which can result in severe damage.  squeeze the throttle lever and relax your grip
                                                              on the throttle lever to vary the engine speed.
                            [ECJ00554]
                        EJU43283                              Weeds tend to become clogged more when
                        Beaching and docking the watercraft
                                                              operating at a steady  speed and at trolling
                        To beach the watercraft:              speed. If weeds may have clogged the intake
                        (1) Make sure that there are no boats, swim-  area, clean the jet intake. (See page 107 for
                            mers, or obstacles near the beach.  information on the jet intake.)




                        90
   95   96   97   98   99   100   101   102   103   104   105