Page 53 - LIT-18626-15-25

UF4N14E0.book Page 42 Friday, May 24, 2024 8:56 AM

Watercraft operation

(3) Enter the 4-digit PIN code, and
select “ ”.

Cruise Assist +4

1 2
1 Cruise assist indicator
2 Cruise assist level
To unlock the drive control mode: To activate the cruise assist:
(1) Select the drive control mode indicator. (1) Operate the throttle lever until the de-
(2) Select the “ ” toggle switch, sired engine speed is reached.
and then push the “OK” button on the (2) When the engine speed reaches the de-
touchpad control. sired cruise assist setting, push the
(3) Enter the 4-digit PIN code, and “CRUISE/NO WAKE” switch. Once the
select “ ”. beeper sounds three times and the
EJU46390 cruise assist indicator is displayed, the
Cruise assist cruise assist is activated.
The cruise assist is a function for maintaining
a desired engine speed within a fixed range
while operating the watercraft. Once the
cruise assist is activated, the set engine
speed can be increased or decreased. How-
ever, the adjustment is limited to a maximum
of five increments above or below the initial
cruise assist setting.
TIP 1
The cruise assist can only be set between en-
gine speeds of approximately 4000 r/min and 1 “CRUISE/NO WAKE” switch
approximately 7000 r/min. (3) When the cruise assist is activated, slow-
ly squeeze the throttle lever to keep it
Activating and deactivating the cruise as- squeezed further than the position at
sist
Activation of the cruise assist can be con- which the cruise assist was set.
firmed by the cruise assist indicator on the TIP
multifunction information center. Check the multifunction information center to
make sure that the cruise assist is activated
before squeezing the throttle lever to the full
throttle position. If the cruise assist is not ac-

42