Page 93 - LIT-18626-15-25

UF4N14E0.book Page 82 Friday, May 24, 2024 8:56 AM

Pre-operation checks

EJU32667
Engine shut-off cords (lanyards) check 1
Make sure that the engine shut-off cords (lan- 2
yards) are not damaged. If the cord is dam-
aged, replace it. WARNING! Never try to
repair the engine shut-off cord (lanyard) or
tie it together. The engine shut-off cord
(lanyard) may not pull free when the oper-
ator falls off, allowing the watercraft to
continue to run and cause an accident.
3
[EWJ01222]
1 Clip
2 Engine shut-off switch
3 Engine shut-off cord (lanyard)

EJU46050
Switch checks 1
ECJ01311
1 Engine start/stop switch
Do not run the engine over 4000 r/min on To check the operation of the switches:
land. Also, do not run the engine for more (1) VX DELUXE / VX CRUISER / VX
than 15 seconds without supplying water, LIMITED: If the lock mode is selected for
otherwise the engine could overheat. the Yamaha Security System setting, se-
lect the unlock mode. (See page 31 for
Check the engine start/stop switch and the
Yamaha Security System setting proce-
engine shut-off switch for proper operation.
dures.)
(See page 31 for information on operating
(2) Push the engine start/stop switch to
each switch.)
make sure that the engine starts.
(3) As soon as the engine starts running,
push the engine start/stop switch to
make sure that the engine stops immedi-
ately.
(4) Restart the engine, and then pull the en-
gine shut-off cord (lanyard) to remove
the clip from the engine shut-off switch

82