Page 79 - LIT-18626-15-26

UF5R10E0.book Page 70 Friday, September 27, 2024 5:44 PM

Pre-operation checks

than 15 seconds without supplying water,
otherwise the engine could overheat.
Check the engine start/stop switch and the
engine shut-off switch for proper operation.
(See page 31 for information on operating
each switch.)
1
2

EJU45351
Yamaha Security System check
Make sure that the Yamaha Security System
operates properly. (See page 31 for Yamaha
Security System setting procedures.)
EJU32667
Engine shut-off cords (lanyards) check 3
Make sure that the engine shut-off cords (lan-
1 Clip
yards) are not damaged. If the cord is dam-
2 Engine shut-off switch
aged, replace it. WARNING! Never try to 3 Engine shut-off cord (lanyard)
repair the engine shut-off cord (lanyard) or
tie it together. The engine shut-off cord
(lanyard) may not pull free when the oper-
ator falls off, allowing the watercraft to
continue to run and cause an accident.
[EWJ01222]

1

1 Engine start/stop switch
To check the operation of the switches:
(1) If the lock mode is selected for the
Yamaha Security System setting, select
the unlock mode. (See page 31 for
Yamaha Security System setting proce-
EJU46050
Switch checks dures.)
ECJ01311
(2) Push the engine start/stop switch to
make sure that the engine starts.
Do not run the engine over 4000 r/min on
(3) As soon as the engine starts running,
land. Also, do not run the engine for more
push the engine start/stop switch to

70