Page 80 - LIT-18626-15-26

UF5R10E0.book Page 71 Friday, September 27, 2024 5:44 PM

Pre-operation checks

make sure that the engine stops immedi- EJU44621
Fire extinguisher check
ately.
Check that there is a full fire extinguisher on
(4) Restart the engine, and then pull the en-
board.
gine shut-off cord (lanyard) to remove
the clip from the engine shut-off switch
to make sure that the engine stops im-
mediately.
EJU46060
Electric trim system check
Turn on the multifunction information center,
and then operate the “TRIM/T.D.E.” switch.
Check that the jet thrust nozzle moves up and
down properly and that the trim setting indi-
cator change according to the operation of
the switch. (See page 44 for information on To check the fire extinguisher, see the in-
turning on the multifunction information cen- structions supplied by the fire extinguisher
ter without starting the engine and page 37 manufacturer. Always keep the fire extin-
for information on the electric trim system.) guisher stored in the holder.
Always carry a fire extinguisher on board. A
fire extinguisher is not standard equipment
with this watercraft. If you do not have one,
contact a Yamaha dealer or a fire extinguish-
er dealer to obtain one meeting the proper
specifications.

Fire extinguisher:
Classification:
5-B (B-1)
Capacity:
EJU40102 2 lb or more
Storage compartment checks
Make sure that the storage compartments EJU40122
are not damaged and that water has not col- Safety equipment check
lected in the compartments. (See page 55 for Check that safety equipment meeting the ap-
information on the storage compartments.) plicable regulations is on board.
EJU32353
EJU44670 Hull and deck check
Fire extinguisher holder checks
Check the hull and deck for damage or other
Make sure that the fire extinguisher holder is
problem.
installed in the correct direction and is not
EJU32657
damaged. (See page 57 for information on Jet intake checks
the fire extinguisher holder.) Make sure that the jet intake is not damaged
or clogged with weeds or debris. If the jet in-
take is clogged, clean it. (See page 101 for in-
formation on the jet intake.)

71