Page 88 - LIT-18626-15-27

UF5S10E0.book Page 78 Monday, September 23, 2024 2:13 PM

Pre-operation checks

than 15 seconds without supplying water,
otherwise the engine could overheat.
Check the engine start/stop switch and the
engine shut-off switch for proper operation.
(See page 31 for information on operating
each switch.)
1
2

EJU45351
Yamaha Security System check
(JETBLASTER LTD)
Make sure that the Yamaha Security System
operates properly. (See page 31 for Yamaha
Security System setting procedures.)
3
EJU32667
Engine shut-off cords (lanyards) check
1 Clip
Make sure that the engine shut-off cords (lan-
2 Engine shut-off switch
yards) are not damaged. If the cord is dam-
3 Engine shut-off cord (lanyard)
aged, replace it. WARNING! Never try to
repair the engine shut-off cord (lanyard) or
tie it together. The engine shut-off cord
(lanyard) may not pull free when the oper-
ator falls off, allowing the watercraft to
continue to run and cause an accident.
[EWJ01222]

1

1 Engine start/stop switch
To check the operation of the switches:
(1) JETBLASTER LTD: If the lock mode is
selected for the Yamaha Security Sys-
tem setting, select the unlock mode.
(See page 31 for Yamaha Security Sys-
tem setting procedures.)
EJU46050
Switch checks (2) Push the engine start/stop switch to
ECJ01311
make sure that the engine starts.
(3) As soon as the engine starts running,
Do not run the engine over 4000 r/min on
push the engine start/stop switch to
land. Also, do not run the engine for more

78