Page 89 - LIT-18626-15-27

UF5S10E0.book Page 79 Monday, September 23, 2024 2:13 PM

Pre-operation checks

make sure that the engine stops immedi- EJU44621
Fire extinguisher check
ately.
Check that there is a full fire extinguisher on
(4) Restart the engine, and then pull the en-
board.
gine shut-off cord (lanyard) to remove
the clip from the engine shut-off switch
to make sure that the engine stops im-
mediately.
EJU47870
Electric trim system check (JETBLASTER
LTD)
Turn on the multifunction information center,
and then operate the “TRIM/T.D.E.” switch.
Check that the jet thrust nozzle moves up and
down properly and that the trim setting indi-
cator change according to the operation of To check the fire extinguisher, see the in-
the switch. (See page 51 for information on structions supplied by the fire extinguisher
turning on the multifunction information cen- manufacturer. Always keep the fire extin-
ter without starting the engine and page 38 guisher stored in the holder.
for information on the electric trim system.) Always carry a fire extinguisher on board. A
fire extinguisher is not standard equipment
with this watercraft. If you do not have one,
contact a Yamaha dealer or a fire extinguish-
er dealer to obtain one meeting the proper
specifications.

Fire extinguisher:
Classification:
5-B (B-1)
Capacity:
2 lb or more
EJU40102
Storage compartment checks EJU40122
Make sure that the storage compartments Safety equipment check
are not damaged and that water has not col- Check that safety equipment meeting the ap-
lected in the compartments. (See page 62 for plicable regulations is on board.
EJU32353
information on the storage compartments.) Hull and deck check
EJU44670 Check the hull and deck for damage or other
Fire extinguisher holder checks
Make sure that the fire extinguisher holder is problem.
EJU32657
installed in the correct direction and is not Jet intake checks
damaged. (See page 65 for information on Make sure that the jet intake is not damaged
the fire extinguisher holder.) or clogged with weeds or debris. If the jet in-
take is clogged, clean it. (See page 111 for in-
formation on the jet intake.)

79