Page 44 - LIT-18626-13-42

UF4S11E0.book Page 37 Thursday, July 29, 2021 9:31 AM

Watercraft operation

EJU40003 engine speed will increase. The engine
Watercraft operation modes
speed can be adjusted to two levels: +1
and +2.
EJU45891
Reverse assist
The reverse assist is a function for temporar- 1
ily increasing the engine speed when moving
in reverse, such as to enter the water
smoothly when launching the watercraft from
a trailer.
This function operates after the engine is
started and only if the watercraft is not shifted
into forward.
TIP
1 RiDE lever
Once the watercraft is shifted into forward af-
ter the engine is started, the reverse assist
cannot be operated.

Activating and deactivating the reverse
assist
The activation of the reverse assist can be
confirmed by the reverse assist indicator on
the multifunction information center.
1

1 “SPEED ADJUST” switch
To deactivate the reverse assist:
MPH
Perform one of the following operations. The
RPM
beeper sounds two times and the reverse as-
Reverse Assist +2
sist indicator disappears when the reverse
14.3V assist is deactivated.
1 2  Relax your grip on the RiDE lever.
 Push the lower side of the “SPEED AD-
1 Reverse assist indicator
2 Reverse assist level JUST” switch when the reverse assist level
is set to +1.
To activate the reverse assist:
 Squeeze the throttle lever.
(1) Start the engine. EJU46280
(2) Squeeze the RiDE lever to the fully open T.D.E. (thrust directional enhancer)
position, and then push the upper side of The T.D.E. is a function for slightly lifting or
the “SPEED ADJUST” switch. Once the lowering the reverse gate from the neutral po-
beeper sounds three times and the re- sition to operate the watercraft at very low
verse assist indicator is displayed, the speeds when the engine is running at idling
speed.

37