Page 68 - LIT-18626-13-44

UF3Y15E0.book Page 62 Tuesday, July 20, 2021 10:30 AM

Pre-operation checks

EJU43221
Jet thrust nozzle and reverse gate check
(EX SPORT / EX DELUXE / EX LIMITED)
Check the jet thrust nozzle and reverse gate
for damage or other problem.
EJU44252
Stern drain plug checks
Loosen the stern drain plugs and remove 1
them, and then make sure that the plugs and
O-rings on the plugs are not damaged and
that there is no foreign material on the
threads or O-rings on the plugs. NOTICE: 1 Stern drain plug
Before installing the stern drain plugs, EJU44640
clean the drain plug threads and the O- Hood check
rings on the plugs to remove any foreign Close the hood, hook the hood latches, and
materials, such as dirt or sand. Otherwise, check that the hood is securely closed.
the stern drain plugs could be damaged,
allowing water to enter the engine com-
partment. Check the O-rings on the stern
drain plugs and make sure that the plugs
are tightened securely before launching
the watercraft. Otherwise, water may 1
flood the engine compartment and cause
the watercraft to submerge. [ECJ00364]

1 Hood latch
EJU40147
Post-launch checks
Perform the post-launch checks in the pre-
operation checklist while the watercraft is in
the water and the engine is running.
To perform the post-launch checks:
2
1 (1) Launch the watercraft. (See page 65 for
information on launching the watercraft.)
1 Stern drain plug
2 O-ring (2) Perform the checks and make sure that
there are no malfunctioning items or oth-
Securely install the stern drain plugs by tight-
er problems.
ening them until they stop.
EJU40553
Cooling water pilot outlet check
Make sure that water is discharged from the
cooling water pilot outlet while the engine is
running. (See page 33 for information on the
cooling water pilot outlet.)

62