Page 36 - LIT-18626-13-99

UF6C11E0.book Page 30 Tuesday, July 19, 2022 4:21 PM

Control function operation

EJU31027 EJU31164
Watercraft control functions Engine shut-off switch “ ”
EJU47111 The engine shut-off switch automatically
Engine start/stop switch “ / ”
stops the engine when the clip, on the end of
ECJ01311
the engine shut-off cord (lanyard), is removed
from the switch, such as if the operator falls
Do not run the engine over 4000 r/min on
off the watercraft.
land. Also, do not run the engine for more
Insert the clip under the engine shut-off
than 15 seconds without supplying water,
switch before starting the engine.
otherwise the engine could overheat.
The engine start/stop switch (red button) 1
starts the engine when the switch is pushed
while the engine is stopped, and stops the
engine when the switch is pushed while the
engine is running.
Release the engine start/stop switch as soon
as the engine starts to run. If the engine does 2
not start in 5 seconds, release the engine 3
start/stop switch, wait 15 seconds, and then
1 Engine shut-off switch
try again.
2 Clip
3 Engine shut-off cord (lanyard)
When the engine is not running, remove the
clip from the engine shut-off switch to pre-
vent accidental starting or unauthorized op-
eration by children or others.

1

1 Engine start/stop switch
The engine will not start under any of the fol-
lowing conditions:
 Clip is removed from the engine shut-off
switch.
 Throttle lever is squeezed.
EJU31212
 Throttle lever is malfunctioning.
Throttle lever
 RiDE lever is squeezed. The throttle lever increases the engine speed
 RiDE lever is malfunctioning. when the lever is squeezed.

30