Page 38 - LIT-18626-13-99

UF6C11E0.book Page 32 Tuesday, July 19, 2022 4:21 PM

Control function operation

is discharged from the cooling water pilot
outlet.
1
2

1 1 Water separator
2 Drain screw
1 Cooling water pilot outlet To drain water from the water separator:
There is a cooling water pilot outlet on the (1) Place a drain pan or dry cloth under the
port (left) side of the watercraft. To check for water separator.
proper operation of the cooling system, make (2) Gradually loosen the drain screw to drain
sure that water is being discharged from the the water. Catch the draining water in the
cooling water pilot outlet. If water is not being drain pan or soak it up with the dry cloth
discharged from the outlet, stop the engine so that it does not spill into the engine
and check the jet intake for clogging. (See compartment. If any water spills into the
page 90 for information on the jet intake.) watercraft, be sure to wipe it up with a
TIP dry cloth.
 It will take about 60 seconds for the water (3) Securely tighten the drain screw until it
to reach the outlet after the engine is start- stops.
ed.
 Water discharge may not be constant
when the engine is running at idling speed.
If this occurs, apply a little throttle to make
sure that water discharges properly.
EJU40323
Water separator
The water separator prevents water from en-
tering the fuel tank by collecting any water
that has entered the fuel tank breather hose if
the watercraft was capsized.
If water has collected in the water separator,
drain it by loosening the drain screw.

32