Page 51 - LIT-18626-13-94

UF4P13E0.book Page 44 Thursday, July 14, 2022 10:30 AM

Watercraft operation

(2) When the engine speed reaches the de-
sired cruise assist setting, push the
“CRUISE/NO WAKE” switch. Once the
beeper sounds three times and the
cruise assist indicator is displayed, the
cruise assist is activated.

1

1 “SPEED ADJUST” switch
TIP
Because the cruise assist can only be set be-
tween engine speeds of approximately 3000
1 r/min and approximately 7000 r/min, the
cruise assist level cannot be adjusted to an
1 “CRUISE/NO WAKE” switch
engine speed outside of this range.
(3) When the cruise assist is activated, slow-
ly squeeze the throttle lever to keep it To deactivate the cruise assist:
squeezed further than the position at Relax your grip on the throttle lever past the
which the cruise assist was set. position at which the cruise assist was set.
TIP The beeper sounds two times and the cruise
assist indicator disappears when the cruise
Check the multifunction information center to
assist is deactivated.
make sure that the cruise assist is activated
before squeezing the throttle lever to the full
throttle position. If the cruise assist is not ac-
tivated, the engine will respond normally to
the throttle operation.

(4) Once the cruise assist is activated, push
the upper side of the “SPEED ADJUST”
switch to increase the set engine speed
or the lower side of the “SPEED AD-
JUST” switch to decrease the set engine
speed. The engine speed can be
changed in the range of the cruise assist
levels –5 to +5.

44